Review on 🍄 Inkbird IHC200 Humidity Controller: Optimize Mushroom Greenhouse with Dual Stage Humidifier Dehumidifier - New Version! by Luis Green

This product was purchased to control an evaporative cooler to operate as a humidifier in a large room. We don't use the dehumidifier function, but it should also work for it. Programming is easy enough with instructions, but NOT intuitive - don't lose the instructions. It would be better if the instructions were printed with a sticker on the device itself. It would also be better if they labeled the outlets. One turns on when the temperature is below the set value, the other turns off when the value is below the set value (dryer function). It has a start delay for the dehumidifier output, which is nice. It has an adjustable dead zone and an adjustable setpoint. It says it can be calibrated but we don't need it. The sensor is permanently connected with a modestly long cable; it would be better if it was extendable or if the cable was longer to allow for better sensor positioning. (I think it's about 6 feet long). As a pre-assembled, ready-to-use hygrostat, this is a fair value.