Review on 🖨️ Creality 3D Tempered Surface: High-Quality 310X310X4Mm Printing Bed by Chuck Hernandez

I bought this for my CR-10. Although I assembled my printer exactly as directed without over-tightening anything, the platform it came off of was far from level. The supplied clear glass was actually a problem. This bed solved my pumping problems immediately. It should be noted that this bed is slightly thinner than the glass bed that comes standard with the CR-10. At least for my standard bed it was about 1.5-2mm thinner. Its adhesion is excellent. I use 90% IPA after each print to clean it. Any adhesion issues I had I could trace back to a mistake I made, either because I didn't have the correct layer temperature, hot-end temperature, layer leveling (still manual leveling), or a speed/cooling issue. I was impressed by how well this platform handles liability. I recommend following the instructions and allowing the platform to cool before attempting to remove a print, especially PLA prints. It really grabs her and you can break it by trying to take it off while it's warm.