Review on 🔔 Genuine Kawasaki Mule PRO-FXT DXT FX DX FXR Horn Kit 99994-0455: Enhanced Genuine Kawasaki Horn for 2015-2020 Models by Corey Listner

My device is a Kawasaki FXT PRO.1. SIGNAL INSTALLATION AND CONNECTION - It is not necessary to remove any part of the housing/grille to gain access to the siren mounting location. This is easy enough by removing the hood cover. Reach your hand inside the square tube (passenger side) and you can feel the small hole in the square tube where you need to insert the single bolt that attaches the horn to the tube. Cutting the zip tie holding the two wire cable with electrical connectors attached to the horn greatly simplifies attachment to the horn before bolting the horn to the square tube.2. INSTALLING AND CONNECTING THE SIGNAL SWITCH - Use a utility knife to cut a square plastic hole into which the switch will be fitted. Then detach the dashboard by removing the quick release fasteners (3 at the top and two at each bottom corner). The tabs can be lifted with two flathead screwdrivers to grab the heads with your fingers and pull up. The wires/connectors that attach to the horn are slightly forward of the steering wheel area. Finding this cable was a bit difficult. but do not confuse the cable with the two barrel connectors next to the horn switch that you intend to use. This can be a little confusing until you find the right wire with the right connectors that fit into the horn switch. THIS ONE. No problem and I'm happy with the horn and switch