Review on Malida L Type Thread Connect Fitting by Sean Copeland
The thread is bad and cannot be closed.
It doesn't matter if you use just one wrap or two of teflon tape, or wrap it so thick you can barely see the threads or anything in between. Then tighten it, it drips, makes it tighter, still drips, tighten until it can't physically tighten anymore and the elbow just bends without tightening and still drips. Drip is not slow either. Wipe away the drip and it will be flowing again in less than a minute. I suspect the threads aren't NPT, maybe NPS (non-tapered). Maybe they are BSP. Simply bad.
- Kitchen and bathroom lights
- Older model
New products
Comments (0)
Top products in 💧 Water Purification
Another interesting products
NANPU 1/2" NPT Air Drying System - 5 Micron Particulate Filter, 0.01 Micron Coalescing Filter, Air Pressure Regulator Combo - Semi-Auto Drain, Poly Bowl W/Metal Gauge
23 Review
NANPU 3/8" NPT Compressed Air Filter Regulator Combo Piggyback, 5 Micron Brass Element, Poly Bowl, Semi-Auto Drain, Metal Bracket, 0-150 Psi Gauge
26 Review
🔧 NANPU 1/2" NPT Compressed Air Filter Regulator Combo Piggyback with Auto Drain, 5 Micron Brass Element, Poly Bowl, Metal Bracket, and 0-150 psi Gauge
18 Review
NANPU 1 FRL Air Filter Regulator Lubricator Combo With 0-150 Psi Gauge, 5 Micron Brass Element, Poly Bowl & Semi-Auto Drain - Metal Bracket Included
20 Review