Review on Desktop Conference Power Grommet Outlet Power Strips & Surge Protectors by Bob Larson

The conference room we used are Ian Brady conference rooms. But unfortunately this is our room so we've made some much needed and long overdue updates. $300 for a desktop power supply and HDMI setup. So after googling I found some videos on how to make this DIY project. So the total cost for me was just under $80 with a socket and a 3 1/8" hole saw. So the tools I needed for this project were: Cut in the drill bit and a hole at the center. Made and the Area rubbed off Unscrew the flange at the bottom of the grommet Pull the cables through the hole and then lower them into the grommet Screw the flange at the bottom of the table that holds the grommet to our room) On Extension cord from the wall power supply to this grommet An extended HDMI that ran from the wall mounted flat screen to the bottom of the grommet A rubber band that conceals both cords so no one trips over the floor .Bam with the table and velcro straps, the room is a lot cleaner and the rat nest of cables got rid of.Total time it took.20 min ut.Not so bad!