Review on 💡 BRISHINE 20PCS 1141 1156 Interior LED Light Bulbs: Super Bright 18-SMD 6000K Xenon White Replacement for Camper Trailer Boat Indoor Lights - Buy Now! by Zack Block

These were a plug and play replacement for my old tungsten bulbs at a much better price than whole replacement bulbs. . The hardest part is removing the old plastic covers without cracking them from wear and tear from the heat from the bulbs. I also like the increased brightness, which is best showcased with clear or no plastic covers on lights, and the move to daylight-balanced colors, which I'm sure will eventually take over the world once people forget about tungsten, like tungsten around the world of candles that glowed/burned with an even narrower spectrum of light. As you can see above I used them in an RV. The lamp socket is also common in running lights and dome lights in cars and trucks. Either way, unless you want other lights to look dull and washed out, it's a great replacement. When I first tried them out, I put an LED on one side of two lights to compare them. As I said, for me there is no turning back, especially at an attractive price. Of course, we all know by now that LEDs consume about 1/10 of the electricity for the same light output and thus generate about 1/10 of the heat. In this case that means about 1/5 power and 1/5 heat to double the light output, or something like that. a table knife between the center pole and the light cover. Using light pressure, first loosen one side of the cap (90 degrees from where you pry) and then the other. Lastly, bring out the middle (where you're peeping) until the end is free. This method is the least likely to crack the old cap. Also note that this is easier in higher ambient temperatures - wait for the device to warm up from a heater or warm weather.