Review on 🔧 Enhance Your Additive Manufacturing with Polymaker PolyMide Samples: Reinforced Filament for Exceptional Results by Ricky Habbani

I dried this filament for 48 hours and still had water bubbles when printing. Even at the maximum recommended temperature of 300 °C, the adhesion of the layers is poor. The sample comes without a coil, which is usually fine. This thread was tied into a knot every 10 minutes. When untangling, the thread tore in several places, which worsened the impression. I would not recommend this to any company that needs to get filament ready to print. The company didn't reply to 2 messages so good luck if you need help. I cannot recommend any premium product for sale to companies due to the practice shown with the product and the lack of response.