Review on 📺 Premium Full Motion TV Mount Bracket | Swivel Articulating Arms, VESA 600x400mm | Fits 42-75 Inch TVs, 16-24 inch Studs, 132 lbs Capacity by Aaron Lewis

I have installed eight of these mounts on 55" and 65" TVs. I don't know what else I need from a TV mount. Key Features: The one-piece long wall plate is fully assembled and can be wall mounted without a TV. Includes a cardboard template to help you easily pre-determine where and which holes to use to attach the one-piece long wall plate Screws to attach the single-length wall plate to the studs provided. Two brackets with the necessary screws attach to the TV, and once attached, you can take the TV and simply hang the brackets on a one-piece long wall plate. Two pipe clamps with screws fix your TV mounts to the wall plate. Lots of extra hardware so you have the screws and standoffs you need. It is best to loosen the six (6) hinge screws before mounting the long wall plate to the wall (not too much, about one and a half turns at a time). You will need a set of Allen wrenches and a set of open-end wrenches Dies (strange but true, I found two different nuts. Please check the opening feel of the panel before installing. To install, first install the two brackets on the TV, then measure the distance from the bottom of the tv to the top of the tv hook on the bracket this measurement is easy to adjust the height of the one piece long wall plate i have noticed that a lot of people want the tv too high in the living room as it puts strain on the neck when i place the tv below 46" off the floor two reasons why you lie in bed and sometimes have to look at a stomach that is too high. i position the bottom of the tv 56" off the floor (check for clearance before installation Find the wooden studs that you want to attach the wall plate to Use a cardboard template to determine the location of the top left lag bolt and which two slotted holes will fit your bolts. Drill a pilot hole for the first lag screw, then use the washer on the lag screw to secure the top left side of the wall panel about one turn. Using a spirit level, position the wall plate, drill the top right hole and use the second screw and washer. Check the level again; Check again the distance from the floor to the bottom of the TV (as planned). Install locking screws three and four. Tighten all fastening screws. Then hang up the TV and plug in the TV. If for some reason the TV is not level, this can be adjusted at this point. Be aware that you may have exposed wires that you don't like. Please read my review of the Datacomm 50-3338-WH-KIT Easy Mount Cable Organizer Kit and PORTER-CABLE 43218 3/16" Spiral Down Drywall Cutout Bit to help you with this issue. Good luck !some attached to metal studs with 1/4" X 3-1/4" T-bolts - for hollow section applications you will need to add lots of washers or thread further when using this part as the threads are not chased far enough to get the bolt After tightening the screw, you will probably want to trim off the excess thread.