Enhance Motorcycle Turn Signals: 2-Pin Electronic LED Flasher Relay for Fixing Hyper Flash with Bulb Compatibility Review

Great little device, no more annoying clicking when the warning lights are installed on my Honda Shadow vt500 86, even though I have a 3 wire system only need 2 wires, the 3. Wire is ground as this is the turn signal is electronic, it does not need to be grounded so it worked perfectly. I got the LED signals on the back and back and now they are blinking properly and not burning out from the fast blinking with a hyper flash effect. For the price it couldn't be beat, I drove 2 hours today and it

Summary: Installed the LED signals and the signals went into Hyperflash. After a little research I came across this relay. Pros: Quick and easy (relatively), connects to OEM wiring harness. Cons: None. Conclusion: Highly recommended, much easier than the resistance setting method. Related products: Rear turn signals: CCAUTOVIE 4 pcs. Super Bright Motorcycle Turn Signals Flowing 12V LED Turn Signals https://www.amazon.com/gp/product/B088PNV5JY Front Turn Signals (Bulbs): BMTxms Canbus BAY9S…

Don't love it when something just "works". I decided to replace the factory flasher relay on my Tiger 800 after my Weisertechnik LED turn signals started flashing erratically. These upgraded LEDs were supposed to work without modifications [which they initially did], but after a few hundred miles they started flashing erratically - something that's hard to diagnose with an LED that should work with a standard flash relay. As a test I decided to replace a relay specifically designed for use with

After buying (and returning) another unit that claimed to work with LED turn signals (but didn't) I ordered this relay not knowing if it would would work or not. Work. It worked as advertised so I'm happy. I used this relay with a set of turn signals I also bought from Revain so I can tell you that this relay works with these signals: https://www.amazon.com/gp/product/B00H9A1KGM/ref= ppx_yo_dt_b_search_asin_title ? dh =UTF8&psc=1 I will say that I built my set of turn signals completely from…

OK but if you plan on keeping the stock halogen turn signal there are a few extra steps that need to be taken. I pocketed it and all four started blinking. I knew what was causing the problem. I cut two wires going to the display on the dash. Then I placed a diode on each wire so that the diode's strip was facing away from the wires. From the other end of the diodes I connected them together and connected the knotted end to a terminal of the turn signal. Then I took another turn signal wire and

As a result of replacing incandescent bulbs on a motorcycle with LEDs, I got an annoying hyper flash. So the next step was to swap the relay. I chose this relay and it worked without any problems. Since it's an electronic controller, I now miss that single "click" of the mechanical relays. But now it is much smaller and more compact. The product came in nice packaging (actually two) but I would have preferred to receive it in a much simpler packaging as it just ends up creating garbage…