🌡️ B&M 80212 Transmission Temperature Gauge Kit: Monitor Your Transmission's Temperature with Precision Review

The jig is fine but when I installed the larger of the two supplied tees on the transfer tube the nut broke before it was fully tightened. The tee is cheap and nasty. I brought this kit as I needed all the parts as I live in Dubai and the hardware is difficult to find. Now I have a cut transfer tube and no fittings to match. Where do you get another one? Just not here in Dubai. To update. Revain went out of their way again and sent me a full set of replacement sensors free of charge, now all…

Sensor junk. The pressure gauge works perfectly. The sensor died after 91 days. It will get stuck at 240 ohms regardless of liquid temperature. Since their guarantee is 90 days, I doubt I'll have any luck getting them to send me a new sensor. Also, the sensor only comes with 1 nut when 2 are needed unless you expect to tighten the sensor cable to the rubber center of the sensor body. Either my kit didn't have a nut, or there aren't enough of them for a proper install. I like the kit but it…

i have the parts, either someone sent them back or they were defective from new and although they leak and don't work i can't remove the t until i can get it somewhere in the coolant line so the liquid does not shoot worse. B+M says Revain doesn't sell their products even where I bought them, they [B+M] won't honor their warranty either, there was no sealant on the sending unit as shown. 9 teflon sheets don't seal it, 1 side has cross threads and I can't get it right with my fingertips

Sensor "worked" but measured about 40F below actual transmission temperature. I called their tech support, they are very helpful. They want the defective meter back but have offered to send a new one as soon as I send them the tracking number for the return. This is the second gauge of this type that I have purchased. The previous one worked great for about 4 years before the sensor fell out intermittently. The complete kit is good and the gauge is the main reason I bought the kit again. Two…

The best additional sensor in my cluster! Easy to read, accurate, and as plug and play as anything I've seen. The temperature sensor is built directly into my Ford E4OD, no adapters are needed (although these were included). The backlight is dated (not LED) but still functional and easy to see at night. "Do you tow or run big tires on your old car? The block is screwed in place of the connector, which is located on the driver's side, amidships, upper hemisphere of the gearbox housing. A small…