Accu-Gage H100X: 100 PSI Professional Tire Pressure Gauge with Rubber Guard for Superior Protection Review

Will not fit any Schrader valves on my van or motorcycle. The plug is much larger. I've never seen anything like it. Here it is pictured next to my corner cassette.

Can't hold the pressure? Unlock button stuck open, used it twice and stopped working. It would be nice to do a print test so you can write that down.

Great tire gauge! I've compared the readings I got from this sensor to others I have and this sensor gave good results and was a lot easier to read. The needle stays in place after checking the pressure, so you don't have to bend down to read it. I would buy another one!

I have been using this type of device for 30 years. A) This latest lost item replacement purchase is set up differently than previous versions. B) The second tire I measured with this gauge failed to pressure lock and the reading quickly reset to zero. Very disappointed.

Looks like a solid and accurate pressure gauge. I tested it with an old and high quality meter from the USA and it was always the same. It comes with a lifetime warranty for the original purchaser, which is a nice touch. How time will behave remains to be seen, but so far satisfied with the purchase.

I ordered this device and received it on time. It didn't seal around the valve stem to get accurate tire pressure readings, and whatever pressure was set in the block wouldn't hold up, leaked. I sent it back without any problems and received a second unit. This fits snugly on the valve stem but will not hold pressure and will leak without depressing the pressure relief valve. Low quality product. Now I'm asking for a refund. However, the return amount shows 0 for some reason

I ordered this to have with me. I liked the feel and feel of the rubber tread around the Accuracies Gage. However when I tried to use it my bushings and valve stem were too close to get a good gauge. I contacted the Jazebra seller and the co-owner responded very quickly. He found the solution to my problem! Excellent customer service, the product seems to be holding up. I like that there is a "pump" button. I highly recommend this product and company based on my experience.

The one I received came with an angled pivot tip - like you see on other similar jigs. I was a bit disappointed because I preferred the straight version for simplicity. The needle on the gauge read about 5psi even with no air and was about 5psi too high. I went to adjust the calibration but when I removed the back cover it suddenly showed zero and now it seems to be measuring pressure correctly - not sure what happened there. I had one of the 60psi versions, probably 20 years old, it was great.

The seal is a flat piece of very soft rubber. It is not pressed or glued. If your tire valve is not in the 12:00 position, the seal will fall out. When the valve is in its usable position, the gasket does not seal anything at all. This can be a one-time mistake. What is not disposable is the inside diameter of the fitting. It's so much larger than a Schrader fitting that it's difficult to keep the ignition centered and therefore tight. It really is rubbish. Now I know why the company is…