Header banner
Revain logoHome Page
πŸ”§ accusizetools ga41 0050 precision toolmakers insert logo

πŸ”§ AccusizeTools GA41 0050 Precision Toolmakers Insert Review

3

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
πŸ› οΈ Workholding, πŸ› οΈ Industrial Power & Hand Tools

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸ”§ AccusizeTools GA41 0050 Precision Toolmakers Insert
img 2 attached to πŸ”§ AccusizeTools GA41 0050 Precision Toolmakers Insert
img 3 attached to πŸ”§ AccusizeTools GA41 0050 Precision Toolmakers Insert
img 4 attached to πŸ”§ AccusizeTools GA41 0050 Precision Toolmakers Insert

Description of πŸ”§ AccusizeTools GA41 0050 Precision Toolmakers Insert

Ideal for holding small parts; can be used either separately or held inside another bigger vise. APPROXIMATE DIMENSIONS: Jaw Width - 15/16"; Jaw Opening - 1/2"; Weight - 11oz.; Jaw Depth - 4/10"; Length - 2-1/2". Square and parallel within 0.0002". Parallelism: 0.005mm/100mm. Verticality: 0.005mm.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 3 out of 5

Moving Jaw Non-Parallel

a little disappointed, not sure if I received a defective product, fixed jaw and body were parallel but movable jaw was not parallel and was smaller than the width of the bit, the fixed one Jaw and body width is 25.90mm while movable jaw is 25.50mm wide, everything else is fine, no sharp edges or burrs to clean

Pros
  • APPROXIMATE DIMENSIONS: Jaw Width - 15/16 in.; Jaw Opening - 1/2 inch; weight - 11 ounces; Jaw Depth - 4/10 inch; Length - 2-1/2"
Cons
  • Crumpled

Revainrating 5 out of 5

Great value mini tool vise for the money

I am a tool and die maker by trade and needed to replace another mini grinding vise that was poorly made. This vise does what I need and seems to hold pretty well and accurately. I would recommend it to someone who needs one of these without spending over a hundred dollars. The vise has a ribbed plastic body similar to that supplied with the end mill.

Pros
  • Verticality: 0.005mm
Cons
  • No productivity

Revainrating 2 out of 5

I liked the vise, but the head of the screw had already started to peel off.

This vise needs improvement. In general, the vise is good. in specification for squareness and the finish is very good. The biggest problem is the clamping screw. I made a small batch of parts and after about 20 uses the hex head of the screw started to peel off. I made sure I had a well fitting hex key (one not included). The screw is tapered, so it cannot be replaced with a regular head screw. I haven't decided yet whether to keep it or send it back. I have a few days to decide.

Pros
  • Rectangular and parallel within 0.0002 inch
Cons
  • There are other interesting options.