Ace Armorshield Waterproof Protector Compatible Review

A must have for any Fitbit product. The faces of their products scratch so easily it's very disappointing. This product will take a little longer to install as it uses a 'wet' installation method which is quite difficult to understand just by reading the instructions, thanks Buddha for YouTube. Check out a few before installing. Due to the fact that the charger for the F-3 wraps around the face when charging, there is also some kind of displacement, blistering or protection. It levels off again

Got this for my new Charge 3 as I didn't have a screen protector on my Charge 2 and my face was scratched. Overall I like it, very similar to other products in this range. However, the instructions for use leave a lot to be desired. Let's start by preparing a solution of water and dish soap. what is the ratio Do you add a drop of detergent or mix in half? It never speaks. Positioning on the face is also difficult. You have a wet piece of plastic that you want to position accurately on a flat…

Although the product includes an alcohol pad, microfiber cloth and dust removal tape to prepare the device for installation, there is no tab or installation tape on the screen cover itself to prevent fingerprints avoid. This makes the coating of the screen too delicate and more prone to misalignment than necessary. The instructions state that you should wet your fingers to avoid leaving fingerprints on the product, but if you swipe the coating across the screen your fingers will likely dry out…

I first ordered Skinomi screen protectors for the Charge 3 as I loved them on my daughter's Alta Fitbit. Big mistake! I used up all 6 in 4 months (and that's just because I was trying to "stretch" them for as long as possible). They unplugged my device for no apparent reason. I've used a number of different screen protectors but never had such a bad experience. I then ordered Ace Armorshield to replace the Skinomi scrub... and it was amazing! I've been using Ace Armorshield for over 2 months…

Some people can just install it. Some have it very difficult. If you're one of the latter, here's what you need to know: CLEANLINESS is KEY! Wash your hands WELL and rinse WELL. Wet your fingers with the application liquid you prepared during installation. If possible, use distilled water in your solution. Choose a room with very little dust in the air. Choose a surface and a BRIGHTLY lit area that is CLEAN. WIPE AREA AND SURFACE with a clean, damp, lint-free cloth. Wear lint-free clothing…