AEcreative 2-Way Antenna Signal Splitter for Uniden, RadioShack, Icom, Alinco, AOR Scanner, Shortwave Radio, and RTL-SDR Receiver with BNC Connector Review

This worked surprisingly well as a splitter for my two high quality AOR LF to UHF scanner/receivers. I know it's only rated for 5MHz to 1GHz, but has less than 3dB loss (standard splitter) from 385kHz LF to 1.2GHz. Highly recommended. N7FAE

The splitter is used to share the discone antenna between the PSR500 and SDS200 scanners. During operation, especially with the PSR500 on VHF and UHF, the attenuation is significant. I live in an area with a pretty good signal, and very strong local signals are fine, but State Patrol takedowns and a few others are faded into the splitter.

Bought 2 of these splitters. They worked great compared to the cheap splitter I had before. As far as I can tell there was no signal loss. My only complaint is that it would be nice if all three ports were BNC. That's why I only gave 4 stars. I have never seen the type of connectors used for this splitter. The cables provided have the correct connectors but limit the distance at which two scanners can be installed.

has been using it for almost a year and one of the wires has stopped working unless I moved it a little. It's okay, just replace the wire and make another one. except that connectors for sdr/scanner/radio are very uncommon. I believe it is a PLA or PAL connector. Too bad they didn't use BNC or SMA for all connections. Overall it worked well, I only wore out 1 cable because I always changed it from SDRplay to portable scanner. I just need to use this "F Type TV Antenna Female to Male Coaxial…

The splitter is used to share the glass antenna between the PSR500 and SDS200 scanners. During operation, especially with the PSR500 on VHF and UHF, the attenuation is significant. I live in an area with a pretty good signal, and very strong local signals are fine, but State Patrol takedowns and a few others are faded into the splitter.

Bought 2 of these splitters. They worked great compared to the cheap splitter I had before. As far as I can tell there was no signal loss. My only complaint is that it would be nice if all three ports were BNC. That's why I only gave 4 stars. I have never seen the type of connectors used for this splitter. The cables provided have the correct connectors but limit the distance at which two scanners can be installed.

used it for almost a year and one of the wires started to stop working unless i moved it a bit. If it's bad just replace the wire and make another one.except that connectors for sdr/scanner/radio are very uncommon.overall it worked fine, i only wore out 1 wire because i always use it from sdrplay to portable Scanner I just need to use this "F-Type TV Antenna Female to Male Coaxial Connector Adapter" then to "F Male to SMA Male" to SMA Cable Too many connections for my liking.