AIBOO 12V LED Under Cabinet Puck Lights: Plug-In with Manual Switch, Single Puck Light for Closet, Counter, Showcase - Low Voltage Wall Plug (Warm White) Review

I can't say anything about durability, but the lamp works well and looks high quality. The 120V/12V transformer is UL listed. Low cost is a definite plus. Two self-adhesive pads are included or can be screwed on. The lamp cords are a reasonable length.

I bought these to install in a small cage I was renovating. It was very easy to install. I just had to drill a small hole to insert the wire and then lightly glued it to the top of the cage. It's very subtle as the light is pretty flat. I like the warmth of the light. I would buy this product again.

Took a few minutes to install, I had to drill a small hole in the top of the cabinet. Side connector so it doesn't protrude. Comes with a sticker so you don't have to screw in the light. There are also wire clamps that close around the wire. This keeps them in place and out of the way. It is very bright and illuminates the entire office well. I am very impressed.

I ordered them because the hole inside the IKEA closet through which the light cord goes does not fit into the usual "plug " fits. fit. It is great! A small, thin wire that breaks apart so it can be threaded through small holes. I bought 4 "natural" lights for my closets and 2 more "warm" lights. I placed one under the overhanging part of the kitchen counter, now it illuminates the spot where we feed the animals. I keep the other lamp in stock ;)

Quite a lot of light, very easy to install. The only downside is that the cord for the handset and the cord for the socket adapter are black and the cord from the bulb itself is white. I want them to be all white, look a bit weird and need the black cords to be hidden.

I needed something to light up Christmas. It easily fit under the "roof" and gave off great light, allowing me to enjoy Christmas even when the light in the room was low. Installation took about a minute. It just takes a little longer under the closet because you need to attach the cord so it doesn't sag.

I bought these for some lithophane I 3D printed for gifts. I didn't want the people I made them to have to mess with batteries (need to be replaced or leak). So I received two of these lights and will be ordering more as they do their job perfectly. In the picture it looks like there is a small "hot spot" (brighter) in the center, but in person it evenly illuminates the lithos. They are sufficient for installation under a shelf, but are not too bright. They also illuminate evenly and not at…