🔧 Enhanced HD-1 Heavy-Duty Handlebar Riser Bushings by Alloy Art Review

Fits very well. reinforced my steering wheel. no more giving and no more bending. also helped to significantly reduce vibration. It doesn't make much sense that this can make the mount stiffer while reducing vibration, but of course it did!

Took about 5 minutes to put on but I use a pneumatic ratchet, loosen both, open one side, switch, do the other side. Sportster 2001, perfect fit. They became less slack with 12-inch Z-bars. Less vibration as they are more solid.

They were very difficult to install on my 94 fxds. Took me over an hour to put them on because they were very tight. I had to use dish soap and wd-40 to get the shaft between the bushings. After all that I don't notice much of a difference. The steering wheel still shakes at idle.

Fits 07 Softtail with 14" Ape Hangars. The OEM bushings couldn't handle the lift and wobbled with any hand pressure under braking. I was concerned that the steering wheel might tip over in the event of a brake crash. These guys are the perfect replacement for OEM bushings, no adjustments needed, my steering wheel is now RELIABLE, perfect!

Does not fit! Undersized metal sleeve. A 1/2" screw won't fit through there. I put the bushing in a lathe and drilled through it with a 1/2 inch bit. Also, the bushing is raw metal, so I suspect it will rust over time. I put a coat of paint on the outside and lightly greased the shank of the bolt so they won't stick together after a few years if you try to loosen them.

They fit my 2016 Harley Low Rider S FXDLS perfectly. I raised the handlebars to 11.5 inches, so I needed stronger bushings than stock rubbers. It was really tight and it was a bit more work than I would have preferred threading a screw through one of the bushings and getting the bushings. through the jacks, but I take it too much slop. The bars are doing great now. Would definitely buy again.