🏍️ Amazicha Motorcycle LED Tail Brake Light Side Mount Bracket for Harley Touring - Enhance Safety and Style with 3/4" License Plate Holder Review

Bracket and taillight well made and look great after installation The only drawback: the license plate light leaves something to be desired. Very low light output and only illuminates the very edge of the panel. Custom Dynamics LED lights will be added to this mount and before and after photos will be posted.

I found this to be a bright nice little kit to complete my bobber build. Unfortunately after 20 minutes of driving on the freeway the lens fell out and the entire brake light started hanging out of the mounting hole so now I'm going down the drain without a paddle trying to find something to replace it and it's closed cheap to worth hassle with sending back.

The quality of this product is surprisingly good but it's useless! The holes required to attach the axle holder to the license plate holder do not protrude and prevent the license plate or license plate frame from being flush with the holder. I mean you could probably get it working by putting the plate and plate frame in there, but that's quite an oversight in my opinion. Very disappointed.

Terrible workmanship and zero quality control. Eight LEDs do not light up in taillight or brake light mode. The white license plate lights glow even brighter when the brakes are applied, and yes, hooked up properly. Cold soldering everywhere, and some LEDs have melted due to poor soldering at the factory. I'm sorry, that's cheap Chinese junk as always. Waited too long to try and install, so the return period has expired.

I bought it for a project bike so I didn't install it right away. When I finally installed it (last week) and took the bike for a 70 mile test ride, the headlight fell apart and went out somewhere on the freeway and I can't find a replacement headlight. Not at all happy it broke on the first ride, maybe the company will send me a replacement light and I'll make sure the tiny screws holding the light are tightened, in my opinion the light isn't worth the money . and if i could i would send it…

So I had a similar one before, but the flashlight body was plastic. Bad idea. First, the grille and lens fell off while driving. Then after I built and installed a lens for it, everything was fine for a while. While removing the rear wheel for the new tire I removed the old one and dropped it six inches to the ground and all the LEDs in it fell out lol. So I returned to Revain. I came across this one which I didn't buy the first time because the other one was cheaper. This is very easy to…

I was actually very pleasantly surprised by the quality of this setup. Installation was very easy if you have basic mechanical and electrical knowledge. The setup came in a vertical format and due to California law I was forced to convert it to a landscape format which was easily accomplished. The LED matrix is nice and bright. Not the brightest, but more than adequate. And all functions work perfectly. Plate holder made of very thick steel. The only negative I can say about it is that the…