🚗 AmeriLite Replacement Crystal Headlights with Corner Parking Set for Ford F150 F-150 Harley Lighting - Complete Driver and Passenger Upgrade Package Review

Our F150 was an 'early' model so the light didn't fit and replaced a few other parts so let's hope they fit because no one has the right ones manufactures. After a few months of operating these trucks, Ford reconfigured the front end and lightened the suspension.

Fits great and looks great! Take your old lights and pre-tune them before installation. Also mount the headlight first, then the side marker. Be sure to slide it into the slots and as others have said remove the support brace from the old side marker and reuse in the new light. The supplied screw will not be accepted. If you don't have the old clips, go to a hardware store and buy a screw that fits the new clip.

Product as advertised BUT if you have a truck built in early 1997 the corner lights will not fit unless you replace the bezel behind the headlights. Early 1997 trucks have a plastic insert that attaches the lights to the dash and then inserts them into the dash. Late 1997 thru 2004 trucks can mount headlights and cornering lights directly to the front panel. After replacing my faceplate with a 2001 truck at a junkyard, they fit perfectly.

Some parts didn't fit together particularly with the parking lights, the main headlight was fairly easy to install but the yellow parking light bulbs were misaligned we ended up removing the white ring and twisting it and then tape it back to fit the bulb. The headlights themselves were as expected, crystal clear as pictured, the headlights are on but they were just headlights and no yellow parking lights. All in all a great product was installed in less than an hour.

I like Crystal lenses along with the price. But mine required some "modification". And be sure to save the factory screws for the side indicators: you'll need them! upon purchase, and [again] I had to make some "modifications" to install the flashlight beams (9007-T2). Neither the body nor the attached cord of the torch rays would fit into the retaining ring without tearing a piece of their retaining ring rim (amerilite) and notching it a bit to allow the attached cord to be inserted!

I have a 2003 Ford F150 Super Crew Cab and Revane said these headlights do not fit my truck. Partly they were right. The headlights fit with no problems, but the turn signals required some modifications to the truck. The right turn signal didn't come on until I unplugged the light to plug it into the outlet. A new lamp will not have the large tab in the same location, so you will need to disconnect the cable connector from the lamp to insert it. For the left signal I had to cut out some plastic