⚓️ Uncracked AnchorFix 2: Enhanced Strength Anchoring Component Review

We only had 15 seconds before it became too difficult to install our shield. It was 78 degrees outside and we had just opened up the tube for the first time and filled our 4 holes that contained our plate bolts. We applied several strips of glue to the back of the panel. In total we spent about 15-20 seconds on it. We wanted to put the screws that were attached to the back of the panel into the holes, but they didn't even begin to go in. The glue was absolutely hard, like concrete. We had to…

For bolting gazebo to concrete deck, 12 total bolts (4 per leg), 1.5" deep holes. The first nozzle was clogged in less than a minute after starting work. The second nozzle was split/cracked (probably during shipping) but after taping it did 75% of the job and then got clogged as well. Finally, I removed the nozzle and mixed on the outside of the tube, which was difficult to push into the holes. Despite poor application, the product sticks/sticks well, so my main complaint is the…

I've noticed that this cement doesn't deliver hardener in an even ratio. It initially releases much more hardener than the resin. This causes the dispensing nozzle to clog very quickly, as the cement hardens in less than a few minutes. After a while, the amount of hardener coming out will be more reasonable and the working time will be reasonable. I found the curing time varied from a few minutes to half an hour depending on how dark the mix was. If I had to use this material in the future I…