🔦 AnzoUSA 841002 7" H4 Universal Round Halogen Headlight: Enhanced Illumination for Greater Visibility Review

Will not fit a 2008 Jeep Wrangler exactly. This is not a real 7 inch light. If there was nothing around the lamp that would fit exactly, the light would be reflected everywhere.

Headlamp is loose, retaining ring does not hold light, I don't know what to do, no instructions or suggestions at all, I understand it's just a bulb but everything, what I ordered did not fit, inferior components

Junk! Don't waste your hard-earned money. You will need to trim the case too much to get it to fit properly. The only useful part are the lightbulbs. The boxes are now in the trash. I only spent a few dollars more and ordered a direct fit for my car. Don't fall for the "matches your car" nonsense.

Please note this item will not fit the 2007 Jeep Wrangler. It's very cheap and doesn't have the ledges to sit in the factory case. The factory headlight had 5-6 lugs in the back so the headlight didn't rotate or move when it hit a bump. After several attempts to get Jerry to work I just gave up! NOT JUST PLUG & PLAY!

If it were possible I would put ZERO stars! Cheap plastic shell, glass lens and lamp attachment. Worst of all are two misplaced tabs on the back that didn't match my vintage 1970's Lotus at all. Too bad I didn't read the reviews before buying. I sent them back and received Hellas; twice the price but 10 times better which I highly recommend. It's just useless!

WORST LOW QUALITY. IS NOT a true 7" lens (6.70") so it dangles in the 7" headlight rim. I had to fill it with rubber. The lens is made of LIGHT glass. The glass breaks as soon as you tighten the screws. Not very noticeable when begging, but dampness is starting to build up. Not recommended Worst headlight I have ever bought. Now the system doesn't allow me to return the auxiliary light I bought. VERY LOW QUALITY Please read!

Luckily they were only $18 each, money spent. The lanterns are smaller in diameter, so the decorative ring is very loose. On the back of the headlight is a large round plastic molding that is too big to fit in the headlight bowl. I tried to change it but to no avail. Also, the bulbs are difficult to remove from the case, and the Phillips screws and clips must be removed. They look great and would be a great upgrade.

I bought these to replace and upgrade the stock headlights on my 3/4 ton IH pickup. They fit and work well, but not without some adjustment and modification to the blade for easy assembly. I didn't find anything that needed some adjustment to fit my truck. I had to enlarge the rear opening to accommodate the rubber boot. I had no issues with the alignment tabs on the back of my app. They are not a true 7" and sit a bit loose on the ring. I wrapped the ring in high temp tape and secured the…