Ballhead Adjustable Applicable Photography Accessories Review

That's cool! Works well, you only need a hex wrench to loosen it a bit, but after that it does the job. I use it with Shinobi Monitor and it works wonders.

The product was AMAZING! It was everything I needed. Not only did it match my rig monitor perfectly, but it also received a free scratch card as a gift. I scratched it and surprisingly won $10 lol. I will definitely buy from them again.

Excellent for a monitor, started using it on stands. Note that this applies to very light items and will not stay in place on larger items. Excellent in all of this! Insanely quick to set up with monitors like the Ninja V.

Very strong and well made monitor mount. Highly recommended. The manufacturer's only suggestion is to replace the "manually adjustable" cold shoe tightening and monitor mounting screws with ones that have holes so they can be easily tightened with an allen wrench.

In general this works fine if you don't need to adjust the angle at all. The moment you try without the hex key it becomes too loose to hold my Ninja V and you need to find the key. I wish they had a lock handle or something.

My rating isn't great but be aware I may have exceeded the weight limit by fitting a 7 inch monitor. small/light monitor, e.g. 5 inches. I bought it to mount a 7 inch monitor on a camera cage. Pros: It's cheap and compact. Cons: The connections came loose almost immediately, causing my monitor to flex a bit. an hour or so while filming and adjusting the angle along the way. I was hoping that the pin would prevent the monitor from unscrewing from the mount, but the pin just seems to snap and…

Actually a very well made device, good workmanship, no sharp edges, all edges are bevelled. Tension both when panning and tilting with the included hex wrench, after that it stays at the set tension so you can easily move the monitor in any direction and stay in place. It attaches with a standard hot or cold shoe mount with a big toe nut which works fine but has a bit of play in the shoe itself and I would have liked a slightly snugger fit but they most likely made it even matches shoes that…

In general, this works well if you don't need to adjust the angle at all. The moment you try without the hex key it becomes too loose to hold my Ninja V and you need to find the key. I wish they had a lock handle or something.

This mount is a monster for its size! The locking rings are smooth and can be gripped to tighten them as much as possible. Use the included Allen key to set the rotation and then you can either tighten it so it's tight or just leave it tight so it can be adjusted manually. I've been shooting for half a century and this is the best cold shoe adapter I've ever seen.

This is actually a very beautifully made gear, the workmanship is high quality, no sharp edges, all edges are beveled. Both pan and tilt tension can be adjusted with the included hex wrench and stay at the adjusted tension, allowing you to easily move the monitor in any direction and stay in place. It attaches with a standard hot or cold shoe mount with a large knurled nut which works fine but has a bit of play in the shoe itself and I would have liked a slightly snugger fit but they most…