🚗 Enhance Performance with Banks 51327 Torque Tube System: A Game-Changer for your Vehicle Review

After 5 months it seems to be working well. Fixed my NOx issue cracked factory manifold around manifold. One star off for unpressed or welded exhaust flange bolts. This made the installation a bit difficult. I had to balance the box wrench on top of the bolt with my fingertip and use my other hand to turn the bottom nut until the wrench caught on the side of the cylinder block, at which point I was able to tighten everything.

I installed a supercharger on my 99 TJ and decided to install this connector as the original connectors are prone to cracking and after the compressor it will be much more difficult to to get to him. To install. This is a quality header and one of the few properly styled headers for tj. Most are known for hacking, but not the revolver. I hooked it up to a Magnaflow SS downspout and had to change the holes to make it work. This DP is hooked into the OE header without modification. Love the sound

Very high quality item with good fit and finish. Pros: Surface finish and welds look great Individually machined head finish Construction feels stiffer than other headers Cons: Bottom bolts are much more difficult to access than the header that came out Flange to the drain pipe has no bolts, this is an added concern when holding one Wrench on the other side of the bolt in a very awkward spot Installation Tips: BUY A GOING BIT SET I cannot stress enough how impossible this job would be without a

1993 Jeep YJ 4.0 I don't notice any change in horsepower, torque or mpg but the difference in sound is big. As in other test reports, the materials, curves and weld seams appear to be of very high quality, it produces a very clear sound when idling and does not become "too loud" as the speed increases. It's hard to find good sounding headers for 6 cylinder engines, but this is exactly what you need. Everything is very suitable for installation. 1 screw could not be reached with a torque wrench,

Very high quality part with good fit and finish. Pros: Surface finish and welds look great Individually machined head face Construction feels stiffer than other headers Cons: Bottom bolts are much harder to reach than from the included header outlet flange to the downpipe has no studs, an added concern if you need to hold that up Wrench on the other side of the bolt in a very awkward spot. a set of impact wobblers that you can buy from Port Freight. You will not get a head on screws 1 and 2…

Replaced my factory manifold/manifold - the octopus tube connected to the engine. (Not all systems) Carburetor compatible. Comes with a new gasket, 2 bolts, injector o-rings (I suggest cleaning them and the throttle body while they are off) and a donut. basically had to remove the engine from the driver's side to get the space needed. And loosen the strap/remove part of it out of the way. It's a full time job if it's just you. There is one screw that is very difficult to access unless you have…