🛡️ Enhance Your ATV Riding Experience with the Black Boar ATV Wraparound Windshield (66031) - Shield Yourself from Wind, Rain, Mud, and Insects Effortlessly! Review

It's universal, but to install it I had to remove other brackets and shift the wires. The wing nuts are hand tightened and the windshield is cracked during installation.

If you don't want to squint then stop by. I hate this wind that shied away. It's terrible. Your vision is distorted and you just can't see the ground clearly because it looks distorted. It protects against the cold, but is dangerous.

Good quality windshield itself. The mount is pretty thin. Hex nuts which should hold it securely when moving. As a result, the windshield comes off in just a few kilometers on a gravel road. The workmanship was correct, but I would not buy this again!

I was a bit skeptical of some reviews but for $61 it's great. Better than my $160 Polaris windshield. I installed it on 2021 cf moto c force 600 and it works great. There is so much flexibility with the installation that I see no problem installing it on a quad that does NOT have a skylight. I rode in 34 degrees today, held the wind well.

Was a little unsure when it arrived. I have a 2017 Yamaha Kodiak 700 with no horsepower or skylight. Mounted without any problems. Amenities as "good", not very high quality, but sufficient. The windshield seems very strong, but I'll take it off while towing anyway. It might be fine at highway speeds, but it retracts and extends with two hex screws.

The windshield itself is of good quality, although smaller than I expected. The hardware is cheap junk and the instructions are a joke. It would have been 4 or 5 stars if the manufacturer had simply upgraded the hardware a bit and had clear and readable instructions. I was able to install it using brackets left over from my old windshield.

In general, the quality of the goods is good. That being said, I have a 2017 Yamaha Kodiak 700. My quad has a headlight and fairing mounted between the handlebars. This windshield is supplied pre-drilled and must be installed on the inside of the handlebars. Since I have a light there is no way to install the windshield and line up the pre-drilled holes. It's a shame, because the price can't be beat and the quality looks good.