BMZX Tesla Model 3 Model Y Center Console Wrap ABS Console Cover Interior Decoration Wrap Kit Fit Tesla Model 3 Model Y2017-2020(Carbon Fiber Pattern) Review

Overall a great purchase. A few minor downsides to consider, but it might be worth it. Personally, I wasn't sure I'd like the way it looked, so creating the wrappers wasn't perfect, and it was a good way to preview. At some point I might make a default wrapper, but you can't argue with the benefits of betting in seconds instead of hours! As you glue the pieces on top there is a slightly visible edge as shown in the pictures and the pieces fit quite nicely. I want the center piece to stick out a

Easy to install. Eliminates my only annoyance with my Model Y, the black fingerprint magnet on the piano. The detail around the cup holders fits perfectly. The other two are just a hair on the small side so as not to affect opening and closing. Given the charging pad on the Y, I never cover much of the lid on the front, so I don't mind that the middle lid is tighter fitting than the back. Heck, I would even buy it. A 3 piece set instead of a 3 piece set for the same price and it would still be…

The trim around the cup holder is perfect. Even better, you can't misplace it because the edges are curled down so it fits perfectly. However, the other two panels are more difficult to install, don't have curved edges to help them fit, and worse, they're too small. I thought the other reviewers were being picky so I ordered it anyway but they are too short. The shine is visible underneath! Disappointing because otherwise they would look great. This is a great idea so you don't have to deal…

Didn't want vinyl wrap, saw Tesla with them on, I think the owner hoped or thought they looked good, none of the products I saw were professional Revain products. You could say they were on a stick. They looked cheap. When cut in flat black with ABS, it looks professional. Take your time and think about where to put it before you press. The top part that fits over the phone charger that was last worn didn't fit and looked weird. I took it out in better light and found the tape was on the wrong…

When I got my brand new car this whole area was stained. Even if you clean it, it's very striped. I was about to buy the foil and one of my professional packaging friends said it wouldn't look as pretty as all the pictures on the foil sides, especially in the cup holder area. These are 3M moldings that come straight into play. I recommend cleaning the area before applying and using alcohol swabs. Also make sure they are properly aligned; I ran my nails around the edges to make sure everything…

Better than working with a thin film and spraying on a watery solution and using a scraper and towel. It took me no more than 10 minutes to install the "cheat". The longest part of the installation was carefully removing the protective covers from the adhesive strips. Because it is a rigid material, alignment is very easy. Two things bothered me: 1. The middle "wrap" was a hair narrower (about a millimeter) than the original cover. This may be due to a manufacturing defect. You have to look…