🚗 Enhance Your Ford Ranger's Style with Amber LED Front Bumper Side Marker Light Smoked Lens Assembly - Perfect Fit for 2019-2021 Lariat XL XLT Pickup Models - Sequential Turn Signal Fender Lamps Included! Review

The fit is not very good and they wobble back and forth so they always stick out on one side. But for the price, they look better than the factory orange lenses.

Pretty easy installation. You look great. The setup isn't perfect, but it's good enough. Bulb, not in the socket itself. the price is right. Would buy again.

Man I was really happy with how they turned out! Won't break the wallet and will definitely improve the look of your car. Much needed modification! Easy to install (watch Kies Motorsports install it on YouTube, there are no instructions on the box) And it's definitely a solid product. I would very much like to order again.

The same Chinese Ali Express junk you can find for a fraction of the cost. Installation requires the removal of both the mirror cover and the mirror glass (which WILL BE BROKEN 9/10 TIMES). Save yourself a major headache, the LED is a single diode under a plastic lens which looks really bad on a BMW. PS if your glass breaks. You lost $130 on a used replacement. Ask me how I know.

Just installed them and was very impressed, they look good when installed and when lit they are much brighter. Then I went for a walk and noticed that they don't glow at the very edge like the originals, but have a little ledge at the end so you can see while driving. Drivers approaching from the side can also see. Maybe for some it's a small thing, but for me it's very important. It's nice to see the lights to make sure they're working and to let you know they're blinking.

Unless you read otherwise you know you need to put this where the bulb is, not in the socket. So just pull out the bulb and it slides in as if you just inserted a new bulb. pop out on one side or the other so it never sits flush with the side of the truck. It is what it is, but from a distance they look a lot better than the factory's bright orange lights, so that's the way it is.

No instructions received and I didn't have the original bulb to refer to. The spade connector plugs into the lamp connector on the OEM housing, not the housing itself. It would be nice if they mentioned it. However, I have two problems. 1, the assembly is terrible. Both sides should not sit flush and pop out as there is too much space between the clamp and the body. The gap is too big. So when you snap it into place, it only slides out nearly half an inch from the front. Looks tasteless…