🔗 SATA III Cable, CableCreation [2-Pack] 8-inch SATA III 6.0 Gbps 7pin Female to Down Angle Female Data Cable with Locking Latch, Red - Enhanced SEO Review

I put together a server and came out with some incredible 2 foot SATA cables when the spacing was about 6-8 inches. They fit perfectly, they're about what you'd expect from decent SATA cables, the locking mechanism is solid, and the cable itself feels quite nice and comfortable. her - just get her and you won't regret it!

These are the thinnest wires I've ever seen. I thought the wires were missing, they were so flimsy. Speaking thin I have to say that they came off the plug. I have already replaced them with something thicker.

This pack was great. You need to switch to an SSD drive. These cables made it easy. I even had an old terabyte SATA drive. So I installed that too. Booted into Windows 10. Both hard drives installed and Windows saw it with no problems!

I don't think the description specifically says they have a low profile for use in tight spaces, but I can't think of any other reason you must have a cable one way out. Here's the thing: The corner connector is huge. It's actually higher than any straight SATA cable I could find. If you need to come out at an angle for cleanliness, this might be for you. If you have to turn right to negotiate an obstacle, you're almost certainly better off using a different cable.

Nothing special here. I had a bunch of SSDs floating on USB adapters and used these SATA data jumpers to finally tidy them up a bit and put them in the box where they belong. They have a clean finish and can be easily connected to the MB (six SATA ports). They snap in well and 18 inches seems long enough to get through the crate to the new SSD resting spots. Recommended . Five stars. For your health!

and this is important because I've had a problem with dangling data cables because routing puts unnecessary strain on the cable. Why can't mobo manufacturers use a vertical SATA mount instead of a horizontal mount on the back of the board where they are so hard to reach! Yes, I'm talking to you, ASUS! I have this problem with all 5 of my computers all using ASUS mobile devices. At least they don't come loose when snapping in because the adjacent cable gets pushed around in a further operation -

didn't look at the pictures and didn't notice. but if you look at your sata device and how the 90 rotation is done, it is bent on the SIDE of the power cable for the device. since you can't use the 90 degree part on the device itself, which is probably where most want to use it. So it must be used for motherboard connections. But of course the 90 degree bend now blocks the SATA ports on the phone as intended. Until this is fixed I would not recommend this cable to anyone as this bend renders it

I can't believe the stupidity of the designers of these cables. The thing about a left or right angle cable is that it has to squeeze into an area where there isn't enough room directly behind the device for the cable exit. The left or right cable has the side outlet of the wires to the rear to save space. Except these guys made the left and right connectors LARGER (deeper) than normal. Anywhere you can't install a regular connector, you're even less likely to install one. Although the flexible