🛵 Glenparts Carburetor for Yerf Dog Dogg GY6 150 150cc Scooter Moped Go Kart Carb -Enhanced SEO Review

. This gave this 100cc scooter more power for towing and descending small mountains. I weigh almost 250 pounds and we designed the clutch and rollers on this machine to operate at peak efficiency. This carburetor is a much needed asset on a small scooter and only Revain sellers have it at an affordable $$$ price and a very quick delivery time. Thanks very much!

My 150cc dolly wasn't working and I'm pretty sure the carburettor needed cleaning. Took the factory carburetor off for cleaning and what do you know the screw heads were snapped off by the manufacturer so the carburetor was unserviceable. Got a new carburetor and hooked it up right out of the box. The car started right away and she feels better than ever. The price of a new carburetor is so low that it's literally not worth disassembling and servicing. The new carb fixed my car and I couldn't…

If I could give less than one star I would. This carburetor overflows causing our car to stall instead of idling and being almost impossible to restart. That means we had to wheel it off the trail and into the garage. no It's funny. Shortly after receiving the part I received an email asking me to contact the seller if there were any issues before leaving a bad review. OK, I have. Not once but twice and got no reply. The item does not work properly, the seller does not respond to messages.

WARNING: I installed this on my Hammerhead GTS 150 Platinum and it didn't work right away. The manufacturer has poor quality control. I had to drill the ventilation duct of the bowl at the entrance. It's an inlet with a short vent tube that's not connected to anything. It goes into the float chamber. This was not drilled by the manufacturer. It took hours to figure it out. We compared the carburetor to the stock carburetor and found that the passage was clogged. After rubbing, the engine ran…

This carburetor didn't fit me. It definitely looked used. For the first time, I immediately noticed that the throttle body was dirty and worn. The red throttle plug was discolored. I installed it anyway and couldn't start the engine. This only works for a second; any gas input will stop it. Then I tried a different carburetor and it worked great. Also, the one supplied didn't have a fuel filter like most others. It's not in the photos so don't expect it, although most others do. Also, the…

This is a Chinese Keihin clone so you know you are not getting the highest quality but it would be nice if it was at least close to what the pictures show or even "New". as described. Let's start with the good. Good: 1) Nozzles were installed when it arrived. Okay, now that we're done with the good, let's look at the bad. The bad: 1) It's very battered and shows signs of previous installation and removal, definitely not "new" 2) The e-choke connector is covered in grease and clearly indicates…

Great carburettor, works straight away. I will share this for someone with a similar situation I went through. I have a new (small year) scooter. My 150cc TaoTao scooter wouldn't start when I stopped. The first thing I thought of was increasing the idle speed. This didn't solve my problem. Eventually, little by little, I couldn't crank the engine at all. Checked fuel supply, no problems. Air supply checked, no problem. Spark checked, no problem. I checked everything I could think of. Came to…