💡 High-Performance 12V LED RV Ceiling Dome Light with Switch - Illuminate Your Trailer Camper Interior Efficiently! (300LM) Review

Although the light is bright white, you need to figure out how to remove the cover to install the device without damaging it. I don't like that the light element isn't replaceable, which means you have to throw out the whole block and buy a new one if the light burns out.

Replaced a lamp over a sink in an RV that must have been hot enough to melt part of the body. This is a great replacement. It's good quality for the price, I like the LED lights. They give brighter light than other lights in my RV and use less energy.

It was pretty easy to install and I like that it comes pre-loaded with constant LED light. However, this thing is bright. I mean, a detective questioning bright about a suspect. Also, it's not a very even light. The brightness varies in the room. It's a bit strange. So not bad, pretty cheap, easy to install but don't place it where you want something like a reading light. Too bright and uneven.

I replaced an old soap dish light bulb in my RV with this one. This model has old holes covered because it is physically larger but a little larger than I would like. First off, RV ceilings are often low, but my HILO actually compresses, so I couldn't buy more than a few blankets for spots in the trailer that weren't in contact with surfaces in the lower half of the trailer. The luminous flux is better than the old lamps.

This is part of the power outage alarm system in my basement over the swamp. The system is powered by a 12 VDC power supply consisting of 8 D-cells; It turns on the siren when there is a power outage in the house. I needed something to light up the area in this case before I could turn on the 120VAC backup power and this light is perfect. It is powered by a 12V DC battery and does not consume much power at all. It has a switch so I can turn it off when another emergency light is on. Under $10…

So far, so good! We have replaced all of our 2015 Forest River incandescent bulbs with this brand's LED bulbs and they are much brighter and don't have an odd yellow cast. They are not only brighter, but also significantly cooler. The temperatures the old bulbs could reach were insane and two of them actually melted the on/off switch and the bulbs inside, and then we decided to replace them. Pretty easy to install if you have some wire strippers/wire cutters and a screwdriver. Easier to install

Very easy to install. It only takes about five minutes including removing the old one and the light looks and works great. The wires in this device are polarized, with red being the positive wire. Holes for attaching a new base. I used larger screws because the ones that came with the kit weren't big enough to fit the mounting holes on the original bracket. I also used larger wire nuts and black tape after putting the wire nuts on. Operation is smooth and easy, and the light is nice and bright.