👍 LA CHOPPERS LA-7361-08: Chrome Twin Peaks Touring Handle Bar - 8 Inches - Product Review Review

Ordered a 12" for my 14 Ultra Limited. I successfully drilled the fairing but couldn't get all the wires through the bars so had to take it to the dealer. 4 hours and $489 Dollars later I mounted the handlebars to my bike and rode off into the sunset.In fact, running heated knobs, controls and throttle sensor cables through these handlebars is absurd.However, they are much more comfortable and better looking than the stock ones.

Looks great on my 2017 Street Glide Special. I'm 5ft 10" tall and they fit great. You don't need any wire extensions but you will need to cut some zip ties and also remove two ties under the fairing to properly connect the wires if you miss all the wiring. Steering wheel. I have installed it in about 3.5 hours with no prior knowledge I would advise you to watch videos on You Tube beforehand.

They fit my 2016 SG perfectly! Polyurethane bushings (required here) and install them yourself! There are several videos on YouTube that will guide you through the installation process very easily. I'm not the best at garage and even I managed to install them with no problem! Very satisfied!

In general the bars are very nice, the look is what I was looking for. Pulling the wires through the bars wasn't too bad, but there were signs of the wires scraping at an angle. The part that pissed me off was in the picture, the end of the throttle body wasn't cut properly and I had to pull the wires back out to cut the burrs. I could have checked them out beforehand, but since they said the bars were laser cut, I didn't think twice. Basically, I'm happy with the bars.

This 12" handlebar looks and feels fantastic. Precisely. I installed them myself on my 2019 Street Glide Special. I didn't have to dismantle any wire connections with the connector. taped them with dish soap. pulled and pushed through the standard wiring. It took me about 3-4 hours to do this. I had never done this before and was in no rush. panel controls. The 5A fuse was found to have blown. So before you start this work, I recommend removing the main fuse or disconnecting the battery. Also…