🏍️ CICMOD CNC Adjustable Kickstand Side Stand - Black Kick Stand for Honda CBR 600 and 1000 RR, 600RR and 1000RR Review

I have a 2006 Honda CBR600 F4i. They're a little shorter than the factory, and the bike leans a little more. I would pay extra and get an OEM replacement next time

Looked great and held the bike up great but I highly recommend replacing the bolt. Now it's just a hammer for me, because the lower part is somewhere on the track!

The footboard I had on my CBR 600RR '08 was just that. It was about as round as the felt tip pen on the end. Now that I have it on the bike! Now he's got a full leg and I make sure to lower the stand and he doesn't punch through the pavement or the ground in general. In the photo I have before and after.

Easy to install, fits like an OEM but it doesn't have a protrusion for you to press on with your feet and allow for that. For me, that's what I needed, my OEM kickstand broke and I fixed it, but my bike felt too straight and it could tip over with very little effort. I adjusted it to a slightly lower height than my original before installing the footrest and the result looks like what I would expect my bike to be tilted (not too low, but also too straight). I've attached a few photos so you can

Ok so after some research I decided to use this stand for my 2000 cbr 600 f4. The package is not listed for the F4 and in response to the question it says it doesn't fit the F4. So I did some research as the F4i and F4 are pretty much the same bike frame wise. F4 and F4i share the same footplate (mount and sensor, length unknown). I just installed it and it works great, but there are a few things to note. My footpeg was installed, meaning the adjuster screw was already screwed in, which of…