🔧 Set of 4 Chrome Bent 90-Degree Angled Bolt-in Valve Stems by Circuit Performance VS90 Review

Good price, on time and reliable. I used them on an old honda vfr bike. I always had a problem with the rear wheel ventilation. Problem solved.

My wheels made a widening a must and this was the answer. Easy to install, great quality and I've ridden thousands of miles with no problems. I highly recommend!

These are great valve stems that I use on my bikes. The 90 degree bend makes it easy to check air pressure. I would recommend to any biker and they will probably work on some car wheels

When installing on the wheel, the threads broke before I could tighten them enough to seal. I've only tried one of the 4, maybe that was it. I'm just a little disappointed in them.

The package arrived on time. .easy installation. looks great too. I'll connect the phone as soon as I have time. If you know your tire opening size will fit, welcome to buy this. I will recommend!

they flow out of the wheel valve. Bought to replace a flat tire. they didn't work at first. So I took the wheel off and removed more corrosion, after that they worked very well. To be honest, it wasn't the product's fault, it was my fault. the pressure is good. bad flow. I don't care about the screwed style, they are definitely easier/convenient to install/remove. work well. Yes. Well.

when i first installed it i overtightened which caused the oil seal to fall into the hole in the wheel. I unscrewed the nut completely and then tightened it until it started to shrink in the wheel hole. I pushed it back until it was flush and looked right. I put the tire on the wheel and pumped it up. Of course the valve stem lost air. The problem is you can't adjust the nut since it's inside the wheel.

Received on time, from USA to USA. __These are not 90 degree offsets, they are 85 degree offsets. When using an external tire monitoring system, clearance issues may arise. I was able to bend one slightly to make room BUT BE VERY CAREFUL not to break the metal rod. __ARD PROBLEM. __The valve works fine but the 2 rubber seals that go to the rim are POORLY constructed, they are SOFT. Tighten and they will burst. I used "Permatex 2" on both sides of the rim and fixed this very slow air leak…