💡 CoCsmart 2PC Flexible Dual-Color Switchback Lights in White: Effortlessly Fulfilling Your Lighting Needs Review

Easy to install. Almost plug and play. I had to cut the turn signals and connect them to the existing connectors. Daytime running lights (DRL) were white. When using the turn signals, the headlights turn amber and have a pattern similar to "sequential flashing". It's a pity that the wires of the cables were a bit thicker (they are quite thin), but what will you do? They work. Honda CB300R 2019

i have used two sets of these lights so far in less than a week the first set one light worked amazon shipped the other to me very quickly i can add a second set , I tested it on a motorcycle battery. worked great, put the lights aside for a few days while I set everything up to install them and now they don't work at all. Don't buy these lights, the wires are very small and they don't seem to hold up more than one link

First of all, as others have said, the cables are as small as they get, they're quite long despite having a lot to do. I only used them as turn signals and just cut off the running lights. Glue is normal 3M glue, nothing special. The zipper holds well but could be better. In general everything is fine. A little cool for what you actually get, but that's just my opinion. Had they used longer wires and a heavier tie it would have been 5 stars without a doubt.

First of all I have to say that I installed these LED lights so that I can be seen from the sides of the bike and not just from the front. So they are not assembled as in the picture on the website. However, they are versatile little things and bright to boot. I have to say that you need to know a little bit about how to install them. But nothing can fix a little research. The daylight effect is nice white and bright. And the turn signal light has a nice scrolling effect that is very…

Fairly easy to install. three wires; Ground, signal for turn signals and continuous or running light. Well taped and it has a little zipper to hold it together with double sided tape. The only thing I didn't like was that the wires are very thin, the wire strippers didn't even have a slot small enough to strip them. And I have a couple of snap hooks so I can easily detach them if needed and the wires were too small to pinch them. Otherwise I had no complaints. The bike was only a few weeks…

They are much brighter and whiter than standard halogen headlight bulbs, which prompted me to order an LED headlight assembly. I replaced my stock front turn signals with these instead of using them with my existing halogen lights. At the same time, the red key indicator on the speedometer lit up. So if you're planning on replacing existing signals rather than adding to them, I highly recommend a voltage regulator or other solution to this problem. It is in no way harmful to your car, just a…