🎮 Cooler Master ELV8: Elevate Your Graphics Card with Addressable RGB Vertical Holder and Adjustable Length & Height Support Review

Cooler Master You are a great brand. What happened to this product? The holes in the bracket are too small for the supplied screws. how? I needed a drill to make the holes half a mm bigger. After that, the installation was easy and the product works well. I've added pictures to show what you need and how to install it. I would like them to fix the holes to fit the screws they provide. Don't even try to install it without drilling more holes. Of course, before using the drill, you can check that

Not for Strix 3080. One spacer is too deep. I have to bend it outwards or it will hit the fans. If they added a 0.5-1 inch gap it would look and work much better. (could probably be printed) I would design it with slots instead of holes so I don't have to struggle with holding the PCI shields and bracket in place when trying to reach and install each screw. Took me about 10 minutes. The next part that makes contact with the card should be thin aluminum. The thick plastic makes jamming or…

Pros: Good workmanship, nice looks, easy installation Cons: Maybe cheaper? Was a little concerned it would fit under the GPU with the GPU power cables, but it went through without much trouble. It screws into 3+ PCI slots and comes with 3 nice thumbscrews with flat/Phillips options. You can still use whatever PCI cards you have installed and they just won't work anymore. RGB looks good and you will need a 5v 3 pin ARGB connector on your mobile phone. I've used it with RGB Fusion (Gigabyte) and…

Pros: Attractive design, no obnoxious branding, technically works even on large 3080 GPUs GPU (should be metal with a rubber gasket on top). It's quite a hassle to install because if you don't mount it over the metal backplates you'll end up with a big gaping hole in the back of your desktop. Attempting to mount this thing on three unbolted backplates is pretty ridiculous. While this technically works on the EVGA 3080 FTW3 Ultra, I had to place the hanging tab between the middle and last fan…

Before this mount I tried two others. One without RGB and while this worked fine, there were minor issues that forced me to return it. The next one was great and a little cheaper. However, this turned out to be too wide and the RGB connector on the bar ended up on the bottom edge. This made it two slots deeper into my sound card. Not only that, it sagged horribly and appeared to be mostly flimsy plastic. Now this one. Wow. Here are some things to look out for: - This thing is made of steel. No…

First of all, I like this holder. Solid piece of metal. Flat black. Not a terribly big, obnoxious logo. Customizable support for compatibility with a wide range of graphics cards. And the full-length RGB address bar is just sexy. The only minor issue with the design is that the adjustable plastic foot feels a little flimsy. A metal pad with a soft pad on top of the pad is ideal. Anyway, I'm hesitant to put the full weight of my Asus ROG Strix GPU on this piece of plastic. It is, and it's a bit…