CUQI Monitor Raspberry Portable Touchscreen Consoles 7", EZ LRL Watch 0129 902, IPS Review

This worked flawlessly, had no problems getting a signal from my Pi4, the touchscreen needs drivers. The only thing I didn't like was that the base seemed kind of cheap and flimsy.

The instructions that came with this monitor appear to have been written for a different version. They are all in the form of pictures and the pictures do not exactly match the product that was shipped to me. However, assembling the case was quite easy. When I was done, the case worked well enough, but it felt a bit bad, like it was made for a different version of the screen. The acrylic body and stand are covered with a protective film that is very difficult to remove. There's no pull tab or…

I'm not sure why they send an HDMI to mini HDMI cable when the screen uses full size HDMI and my computer doesn't have mini HDMI making the cable useless! The screen size was small, but that's what I expected (set the resolution to 150% for on-screen reading). Broke a small frame before I could assemble it, didn't think it would be so flimsy. In general, it served the purpose for which I took it, but I will not buy it again.

The monitor worked fine but the HDMI camera turned off slightly. The insides remain open. It needs to be assembled and the screen doesn't fit on the bezel. There is a small crack between the screen and the frame. It also doesn't stick to the stand and falls off too easily. The supplied cables are too short.

Not sure why they come with an HDMI to mini to HDMI cable when the screen uses a full size HDMI and my computer doesn't have a mini HDMI making the cable useless! The screen size was small, but that's what I expected (set the screen reading resolution to 150%). Broke a small frame before I could assemble it, didn't think it would be so flimsy. In general, it served the purpose for which I took it, but I will not buy it again.

The monitor worked fine but the HDMI camera turned off slightly. The insides remain open. It requires assembly and the screen does not fit the bezel. There is a small crack between the display and the frame. It also doesn't stick to the stand and falls off too easily. The supplied cables are too short.

I use this screen to connect to my Etherium mining rigs. Works great for that. I would give 5 stars if the included small stand was permanently attached. Now I use two large rubber bands. assembly required. But it's easy.

Good picture but no connector protection. Good price and lack of drivers needed to disable this monitor. Another complaint about the lack of a switch off switch.

If your computer has USB power when the computer is off (most of them) it will stay on with a blank screen the entire time the computer is off.

This worked flawlessly, had no problems getting a signal from my Pi4, the touchscreen needs drivers. The only thing I didn't like was that the base seemed kind of cheap and flimsy.

Good picture but no connector protection. Good price and lack of drivers to disable this monitor. Another complaint about the lack of a switch off switch.