🔧 Tension Pulley | Industry No. 89097 Review

My car is a 2002 Sebring that requires removing a stuck front wheel to access the serpentine belt. I decided to go ahead and replace the tensioner since I had to remove it anyway. The new part fits perfectly. I had to remove the bushing that comes with the kit, but it turned out to be pretty easy. Seems to be a quality device.

before I installed this I had a squeaking noise from the pulley on a 2003 300m special. After installation the noise just went away, I did a little research on this pulley, it's equivalent to a gate, the only thing I don't order a gate is because no seller sends a 300m booster generator pulley to Canada . Contact Contact me at riddickfast@hotmail. com

I didn't hate this part, in fact what I bought from AutoZone was a Dayco. The problem is that the Revain filtration system, which puts up a green banner that says "This part fits your car," isn't always accurate. I needed a 3 inch pulley and for some reason they sent a 4 inch pulley that doesn't even fit in the 2.5 liter jeep engine. The snake belt I bought at the same time was top notch so it works most of the time. So this is less a product review and more consumer advice!