🔧 Neo Chrome Shift KNOB Boot Retainer/Adapter for Manual Gear Shifter Lever 10X1.25 - Enhanced SEO Review

It was too small to bolt on my 2003 Acura CL Type S 6 speed so I had to cut it to M10x1.5 ( luckily I had it handy). After I did it fit perfectly and looked infinitely better than nothing (there was nothing in my shift knob to cover the top of the shift boot). It would be nice if it came with a zip but overall pretty good value for money.

This is just the last item on your shifter when you have a gap between the boot and the grip. Mine filled the gap and made the shifter much nicer. The only problem is that the duster has to go in the groove, but I have some kind of plastic insert so I just left it under the adapter. It still looks great and works just like the original nut for tightening the shift knob.

Purchased so I can replace the shift knob on my 370z without the unsightly "gap" between the knob and the factory trunk latch. This adapter is simply pushed onto the shift shaft and screwed on completely and smoothly. Fitting my non-original boot to this adapter also only took a few minutes (to ensure proper alignment) and a very strong strap secured the boot to the adapter. Very easy.

This is exactly what I needed, it fits perfectly. The only small problem I had, and not so much the adapter's fault, was that my boot did not fit on this lower part, it was too wide, so I had to take the boot off and remove the rubber element in my boot as a zip -up adapter. what works, it looks really good, just a process, so be aware that you may need to make some modifications if your loading port is too small, since the bottom of the adapter is very wide.