DNA Motoring HL-OH-CS99-4P-SM-CL1 Headlight Assembly (Driver &Amp Review

Nice Headlights But As Mentioned Water Was Collecting At The Bottom Of The Drivers Side Assembly. Not just some moisture - it was 1/3 full of water. The good news is that I found out why! At the top of the assembly there are two holes covered with a mesh. You don't know what they are for. heat dissipation? Anyway, I dried the assembly and sealed the holes with small pieces of electrical tape. Problem solved!

I bought them back in May of this year! Was so excited to receive them. On arrival I took them to the shop to have them fitted and when the headlights were removed they were smashed. So Revane sent a replacement. I exchanged them and sent them back. I noticed moisture in the turn signal assembly, contacted the manufacturer and was told they couldn't help me as I bought it through Revain. plastic is cheap. Not easy to install. When closing the hood, a turn signal block jumped out of the nest…

I needed this headlamp kit when building my more expensive projector. I chose these because they were cheap and I've bought other DNA car accessories for my truck and they've been great. These are not very good. Light output was good, not great, but if they came from stock I'm sure they'd come in handy. Biggest problem even though we are facilities. I had a lot of trouble getting the passenger side to fit properly. And then on the driver's side there was a gap about 1/4 inch wide between the…

Probably one of the worst headlight kits I've ever bought. I've owned a variety of cars and replaced many faded factory headlights with aftermarket kits. This set was packaged very well. Opened it up and got ready to install. I started by removing the top cover. I removed the headlights from the old ones. Lower cases removed. Started installing the floors. The passenger side fits perfectly. Up and off to a good start. Relocated to the driver's side. The installed bulbs snapped into place and…

Light received on time. After taking it out of the box and comparing it to the original factory headlights, I could see that these assemblies were definitely smaller. Headlights don't fill the space allotted for them in the grille. The next problem was installing the lightbulb assembly. The socket blocks for the right and left high beams will only fit if you disconnect the assembly from the wiring and partially reinstall the assembly into the housing before reinserting the wiring into the…

Above all, they look great! Compared to the factory headlights that have been plagued by the southwest sun for the last 16 years, they are amazing. Installation was pretty easy. They are fairly easy to assemble at factory sites. I can agree with one reviewer that the quality of the plastic used seems a bit low. For example, when the headlights were on for an hour or so, the body seemed to soften a little from the heat. (It's hard to expect much from such a cheap headlight kit, though.) When…

I don't usually write reviews like this but I'll make an exception for these headlights. I bought these headlights in early January and finally installed them about 5 weeks ago. You look great. I'm very pleased with how clean they make the truck look. Installation was easy, it's not rocket science, just take your time and don't drop it. As you can see from the photos I now have moisture/condensation on the underside of the headlights. This happens on both sides when it rains and when it is…