🚗 Hitch LED Light: EBESTauto 4 Inch Tow Hitch LED Lights + 2 Inch Towing Hitch Mount Brackets for Truck Trailer SUV Pickup - Dual LED Off-Road Driving Light Bar Review

I bought this product thinking it would be great, was very disappointed when it arrived, holes were not fully drilled, did not fit the hitch and did not line up properly to stand up 😞. Now I have a lot of scrap, I definitely do not recommend it to anyone.

Эти фонари кажутся очень хорошими, проблема в том, что в рекламе указано, что они подходят для 2-дюймового ресивера, которого нет — убедитесь, что вы заказываете 2,5-дюймовый ресивер для 2-дюймового ресивера, Revain not suitable. without knowing it, I asked the question and got the answer that was posted in the ad.

No connection instructions. He recommended buying a 4-pin trailer adapter I made, but it's not even designed for that. I wanted a plug and play installation. I don't want to pay anyone to connect. It shouldn't be difficult to design a system that plugs into a trailer's wiring harness. Lots of decorative lights.

Installed on a Wrangler Jeep as an underarm backup light. As expected, the installation took a whopping 5 minutes. Popped them in and was surprised at how bright they are. They're so bright I can't use them for everyday use like grocery stores or the mall, but when I'm out in the middle of nowhere in total darkness these preforms perform exceptionally well.

I would like to start by informing you that I am returning this product for a refund. My reasoning was simple: I have a factory-installed heavy-duty, stock hitch, and I ran out of space to mount it. It was the only car I had with her bumper. If you're even considering this, I'll recommend it. The well-designed plugs connect directly to the trailer's factory-installed light plugs. And it's very bright.

I bought this item thinking it would fit my 2" hitch. only one problem I assumed it was within the dimensions they were talking about, but it's not. That's all guesswork. My Class 3 clutch is 2" internal (like most) but 2 1/2" outer (like most Class 3 clutches). I'll be returning them and getting one for a 2 1/2" hitch. They're a great system to boot. Well done and great lights.

The headlight wires can be slightly longer to hide under the bumper or out of sight. Holes also had to be drilled for screws. In addition, it is easy to install. For other customers I have used 12 volt power from my torpedo plug and routed a wire to the cabin for the switch, then also plugged in a spade to disconnect from the back of the switch for removal. The mount is quite narrow so I could see the lights getting in the way of the safety chains. These are very good headlights!