Enhance Your Honda 9th Civic Interior with Eiseng Genuine Leather Black Thread Gear Shift Knob Cover+Handbrake Cover Stitch-on Wrap: Must-have Accessories for 2012-2015 Models Review

Good: it's great, the leather feels very good in the hands, the design is well made and nice (I ordered black on black). Bad, the only bad thing is that my 2012 Honda's fit was too small, didn't close 100% and left 3-5mm gaps. I tried deleting it but no. I even destroyed a small world. After installation, you don't see the interval, but you know it's there. I would still buy it again. Now I had to remove the steering wheel so it could be sawn. Even then it took me about 3-4 hours from start to…

It was a painstaking DIY project but the material is of excellent quality (genuine leather) and looks very neat. I rate this product 5/5. It takes a few hours (several hours) to assemble, but at the same time I had fun using YouTube videos as a guide rather than tutorial videos or instructions (I didn't find them that helpful). Also, I did what several people recommended and only used double sided tape at 12, 3, 6 and 9 o'clock, and very sparingly and as needed in between. Great product, very…

I used this product to replace a 4 year worn steering wheel cover, it only took about 3.5 hours, the kit came with everything you need. After watching a video online I decided to do it myself and even used double sided tape - it works, just take your time and be patient - it's great leather and was a bit difficult to stretch. Outside. The key is to position it correctly and only peel off the tape in certain areas so it doesn't move - was very pleased, if not quite perfect - but looks great and…

There were no cases specifically for the SI model. The SI has a plaque on the underside of the steering wheel that needs to be cut out. I used old masking tape as a template for the hole. I didn't follow the instructions that came with it as I used to make steering wheel covers. I used rubber contact adhesive instead of the supplied double-sided faucet and removed the steering wheel from the car. While this can be done without removing it, it does make things a bit easier. I believe this film…

Mine just finished - took me a total of 4 hours to get it to where it is. A few moments Too bad I didn't use glue because it was a lot harder to get it in the right position. I feel like there are only a few points that actually need glue to fit properly. - This project is HARD if you've never done it before and want it to look good. By good I mean perfect. It probably looks ok to a passenger in my car, but I want it to look exactly how it was supposed to look from the factory. oooh, if you're…

Overall I am satisfied. But be careful. This setup is not as easy as it seems. There are pictures in the manual but they are not for my car and they are written in broken English. I found a video on YouTube but it didn't come with any comments or advice. In the video they made it very easy for themselves. Apparently they installed a lot. I recommend not using tape between the spokes. This allows you to completely close the gap as you sew. Duct tape prevented this for me. As you can see on the…