🚦 Evomosa Mini Stalk Arrow Light Motorcycle Turn Signals Lights 10mm Universal LED Indicator Blinker Amber Lamp (2 pcs) for Enhanced SEO Review

I was initially skeptical about this bike, the taillights are only $10. However, after dropping the bike, my rear left taillight broke so I had to replace it. The OEM headlights were $30 each so I decided to give them a try. Installation was easy and they fit perfectly. The smoky accent really makes my bike look amazing.

They are small and the stem is much shorter than those on the bike. But that's exactly what I wanted! One of the originals on my bike broke when I crashed. With them, this will be less likely, although not impossible. But I'll try not to fall. They're flashing fast, and now my rear turn signals. But I also like it and I don't feel like figuring out what resistor and how to install it.

I was surprised at how short they were but that's my fault as the specs are in the mail. But still they are quite bright during the day and look very stylish and seem quite resilient. Good price for quality. Warn potential buyers. These are LED lights and if you are installing them on your bike that previously had halogen lights you may need extra work to make them work. This is not due to the lamps, but to the way direct current works. Google what to do if you run into problems.

Bought a set of 4 of these bulbs to replace the huge ugly standard bulbs with my 1985 Honda Rebel 250. They were easy to install and much brighter than the originals. The only issue I had was all four flashing, but I just had to turn off the check engine light on the instrument cluster and now they all work great. I used an adjustable turn signal relay with them, even with the relay the resistance is too low to keep the indicator light in circuit. I've heard you can add a diode to fix this and…

Well I installed them on my 2000 Ducati Monster which appeared to have an odd wiring situation: a small gauge on the speedometer plate that caused all four beeps to light up at the same time. When I found out that I had to do a little custom wiring using a 2 in 1 diode harness and add an extra ground wire coming from the cluster display, everything worked great, bright enough. It sounds a bit complicated, and if you're one of those guys who decided learning how to use a tool kit wasn't worth…

I bought these because of the decent reviews. There are NO instructions included. Yellow wire is positive, black is negative. They are very well made and quite bright for the price. They are very short and small. The lens section is approximately 1.5 inches wide and 1 inch high. I will take some photos of my 2018 MT-09 after receiving the adapter mounting parts from TST Industries. You will need 2 sets ($4.99 each) to complete the front and rear signals. Kit includes two oval plastic "plates"…