💡 Enhance Your PC Aesthetics with PC RGB LED Strip Light: White Silicone Housing, Magnetic Design, 2PCS Strips, 42LEDs, Compatible with ASUS Aura RGB, MSI Mystic Light, ASROCK Aura RGB, Gigabyte RGB Fusion - Perfect for 12V 4-Pin RGB LED Header! Review

I hate LEDs that are attached with glue but they are very easy to apply. They're magnetized (obviously) so they stick to the top of the case and don't sag. They're pretty thin, so they're easy to hide. You can plug them into any bar, which is handy for cable management and convenience. They are very bright and work well with AURA Sync.

I finished my first build and wanted to shed some light on my case. I have an ASRock B450 Mini Itx gaming motherboard and decided to use unlit RAM to make sure it works. All requirements were thus fully met. It connected instantly and using ASRock software I was able to customize it with a variety of colors. The magnets were of good strength and I made sure the strips unrolled. I also managed to tuck them into small gaps and use the leftover zipper to trim the extensions. The lights are pretty…

I installed them on an Asus Z390-E ROG Strix motherboard. I am happy to announce that they work with AURA timing! Perfect pairing and syncing with no issues (about 1 hour after installation). The only downside I can think of is that the included magnets stick very hard or miss. My case is NZXT H510, the stripes are placed behind the NZXT screen on the back and across the top of the case. While the middle magnets held, the magnets at the end of the strip didn't. I ended up using tape to tuck in…

When I opened my box and saw this, I didn't think they would work for my system at first. Wires like these two felt a little long and the connectors felt a bit unwieldy, but after wiggling around for a few minutes, I quickly realized that it would work! Once I figured out where to put them, everything fit like a glove, slipped in the extra wire and connectors, and I was blown away. I am using a Rosewill Cillinan MX case and it looks like they were made specifically for my case. The extra wire…

I researched this for a while and finally decided to buy based on the fantastic reviews that customer service is so easy! They were surprisingly easy to install, with instructions on the back of the box. I saw a couple of reviews mentioning that the magnets aren't strong enough to hold the top LED and I stumbled across that too. Command strips later and it works amazing, not to mention some command strips for the remaining cable. Incredibly bright. I couldn't be happier. Once it's plugged in…

Installing it on my ASRock FATAL1TY B250M motherboard was pretty easy as it has a 4-pin RGB connector. The installation problem was that the light strip magnets kept losing traction while I was trying to hide the wires. I downloaded ASRock RGB LED software from ASRock website. The correct RGB header software for ASRock motherboards can be found under the Support -> Downloads tab for the specific motherboard in your computer. The software seems to be specific to each motherboard. While the…