Feniex H-2209 - Cannon 120° LED Hide-A-Way (V2 Inline Driver Lights & Lighting Accessories Review

Guns are worth their money and very effective on the road. I will definitely be buying more for my car when I need to update the rest of my signature lighting. After that, Fenex will be a full setup. I have some old t3s on my car with various amazon brand headlights and a yellow glow stick from an old cop car and now guns. This entire lighting is controlled via the fenex 4200 mini controller.

To say they are incredibly bright is an understatement. I tested 4 of these WHITE LEDs in my house in daylight/daytime and they are like 4 dedicated flashes for a 35mm SLR, only about 2x brighter! Unbelievable! Note that the built-in heatsink only gets very hot after a few minutes in strobe mode. But according to the instructions, this is normal, especially with an LED that shines so brightly and brightly! "I can't wait to install them in my truck.

Nice solid little flashlights. Your V.2 version does not have a "Dim" mode for the navigation lights and if you have set them up as an additional tail/turn signal use the brake release function with caution as it will flicker at every turn and the signal will go momentarily out. You really need to integrate a "flashback" controller to override other modes while the turn signal is flashing. Also remind the device that it flashed the brake pop the first time you applied the brake and not every…

Very bright light output (amber/white). Only the programming is less convenient than Abrams LED (You can only change the pattern to one I can't compare it to Abrams light output. I didn't buy them because I don't think they offer 3 independent modes with override functionality. The gun offers and therefore I can use them as DRLs, blinkers and ambers Flashing lights, all in one!

Great product! I bought a pair of Fenex guns to put in my pickup truck taillights. I have two colors, yellow and transparent. I replaced the stock reversing lights with cannons. The hole was already the right size so I didn't have to drill the 1" hole required for installation. I set up two different flash patterns for modes 1 and 2 and set mode 3 as a constant white light for the reverse light function, which takes precedence over modes 1 and 2. I connected the mode 1 and 2 wires to separate…

Very bright, I've fitted them to the tail light, cab tail light and headlamp housings. I installed devices in the taillight to turn on white LEDs when the truck is reversing - they are probably 3x brighter than the factory taillights which I removed to install. The devices I installed in the cabin tail light will turn on white LEDs when you turn on the cabin/bed tail light switch. They are also much brighter than the factory bulbs which I removed to install. The devices that were installed in…