💪 CNC Aluminum Foot Pegs for KX65/KX80/KX100/RM65/RM100 - Black Footrest Footpegs Pedals 2000-2020: Check out our High-performance Upgrade! Review

Direct peg replacement for Talaria Sting. Even OEM springs are reused. They rock and are relatively cheaper than big brands!

Was very difficult to fit but when fitted they looked good and were of high quality. Highly recommended, just make sure you have a few hours to get the job done.

Looks great but doesn't fit. It's a bit thicker where the nib goes in, so the pin won't go through unless you cut it off a bit to make it thinner.

They look great, the paintwork is a little scratchy but that will sooner or later. You get what you pay for. Although 100% better than stock. Also excellent customer service.

Much better than standard pens! I used 2 of these sets. 1989-2002 Kawasaki KLR 250 and Yamaha TW200. Both had to be modified with an angle grinder but I would say it wasn't difficult and took about an hour to get them working on both bikes.

Easy enough to install if you're a bit mechanically inclined. The bottom mounting holes in the pins need to be slightly enlarged to 7/16" on the KX65. A few seconds with a small step and you're good to go. I mounted two sets on two bikes in 30 minutes.