Genuine Nissan 28910 9FD0A Windshield Assembly Review

Easy to install. The quality seems good but make sure to keep the original brackets so you can move them around and screw them back to your Titan.

Very happy with this part. Direct installation. It fits very tightly to the air intake filter, so close. Before disconnecting the water pump hose and electrical connections, two small screws need to be unscrewed. Installation took about 30 minutes. Including pump and tank.

Tip: Remove the air inlet during installation - that saves time and nerves! Remove the top of the airbox, remove the middle and rear 10mm screws from the airbox, then you can gently pull/pry the bottom airbox up and out with the front screw still in (push the rubber grommet to install the screw with enough starting force). This makes replacing the washer fluid tank much easier. The block itself is an ideal replacement. I used that on the Armada and just left the backline disabled as I never use

OEM Nissan. Fits perfectly and now I can clean my windshield again. This is probably a little too comprehensive an overview, but curly images are always great when shopping online. There are only two screws "circled in red in the photo" and two connectors. I was able to remove the connectors without removing the air intake using long needle nose pliers and a flathead screwdriver, being careful not to use too much force and risk breaking the connector. After removing the glass, be sure to swap…