🛠️ Gikfun GK1008 Large Gold Plated Proto Board PCB DIY Kit for Arduino, Solderable Breadboard Review

Good circuit boards, well soldered. As others have said, the power rails don't line up with the main through holes, but I don't see that as a problem. Note that they have slightly more rows of main pins than "regular" full-size breadboards, which typically have 60; This board has 67 rows. That's 10% more than Adafruit's full permanent prototype at 60.

I really like this proto board. It's styled after the standard proto breadboard, but slightly longer. The solder adheres to the traces with relatively low heat, which is ideal for soldering the Arduino NANO directly to the board without damaging the board with heat. I have used them in the past and will continue to use them in the future. I highly recommend this product.

could have been chosen The advantage of them is that they are constructed exactly like regular breadboards, making it easier for you to transfer your breadboard design to a permanent PCB. Now I rarely use other PCBs. The copper traces are solid and not easy to separate from the board if you need to desolder something. Also, the board is double-sided, which is sometimes useful. Just make sure to use enough good quality flux.

I'm building an 8-bit computer with logic chips for a science fair project with my niece. I bought them to reproduce mockups to simplify the project. Just received - take the solder clean - very durable and visually appealing! They're a bit more expensive than standard Chinese stripboards, but if you're not into mass production, they're worth it!

I bought these two boards: big and small. They are well made with clean printing and good traces of copper and plating through. They accept solder well and I had no issues with copper delamination even after removing and re-soldering the components. The inner rows are connected from left to right with a gap in the middle of the board. The copper pins can be cut if you need to change the standard wiring - just make sure you cut them on both sides of the board. (I've used them both ways with no…

This is a comparison of two style boards: 1) Adafruit is bright white and Gitfun is dark red. I'm giving it four stars because of the color of the board. I prefer the contrast of the parts on the Adafruit board and on the Gitfun2 board) The Adafruit board has three mounting points equidistant from the center of the board. Gitfun has four mounting holes, one in each corner. Each of the four mounting holes is plated and attached to a solder pad next to the mounting pad. This is great if you want…