🔌 GlowShift 1/8 BSPT Male to 1/8-27 NPT Female Thread Adapter Reducer: The Perfect Gauge Sensor Sender Solution Review

I installed this on my 1JZGTE engine. This allows me to install a new AEM oil sensor block on the engine so the ECU can read the pressure.

I have a 1979 Honda CB750 DOHC chopper and I needed it to install a mechanical oil level gauge and it worked great to go from 1/8" BSPT on the engine 1/8 to change 8 NPT for gauge.

Thank goodness I was able to hook up a manual oil gauge to my 1985 Nissan 720. I couldn't figure out why it wasn't working. don't carve but that was enough difference in carving.

I recently bought a new high quality grease gun. However, it was made in Canada and had 1/8 BSPT fittings which were not compatible with my 1/8-27 hose thread. This adapter solved that problem. Well done. would recommend.

Used this to install an oil pressure switch on my 2004 Subaru WRX. Worked perfectly for my needs. I installed a plug for the generator in the forward galley. Seems to be of decent quality. Not sure if other reviewers said it broke. I screwed it on pretty tight and it's holding up well. This is a brass fitting, what do you expect?

Ordered for my 04 Fozzy Xt and for use with my Prosport oil press transmitter but it made it too big to use with Subaru OEM galley plugs in the front and rear I ordered a straight 1/8" Npt M18X1.5 male connector and used the hose of a grease gun to move the transmitter to the fire wall. I was just lucky I think I have this part now, well worth it not to return it

worked exactly as expected. Used on my Subaru Wrx Sti to install an oil pressure sensor in the port under the alternator. Use this instead of the Prosport adapter. I cut threads from my thread block into a new adapter. Luckily the stock dummy sensor adapter is still back, I just used it over this to install an aftermarket oil pressure sensor.