GOLDPAR Driver Compatible BBM3 69 320A 75 BBM2 69 320A 75 Review

Didn't fit neatly in my car, Mazda 3 2012. A bit long and the part of the visor that goes in the clamp doesn't fit properly. It's all cheap plastic and it feels cheap. If it was a term paper, then it was the minimum required to pass.

The dimensions are slightly different than the 2010 Mazda 3, so they don't fit, but they still hold up. Also, the sliding mirror door is very difficult to open on what I got. It feels like it's practically glued on. Otherwise it looks exactly like what came with the car.

This visor is good for what you pay I think. It's a little larger than the original mirror, but it's hard to tell unless you really know. Sometimes it falls out of the holder because of this. while it works fine. The mirror is a little difficult to move, but may loosen over time. Installation is simple and straightforward.

Put an old visor against a new visor and they look the same. But when you install a new sight, the section that's pinching on the right is 1/8" OFF! He'll still crop, but he's not keen on it. Also just a word to the next one - make sure the Pins are straight when you mount the clamp - mine were bent and I had to straighten them.