🔦 2pcs GOODKSSOP Super Bright U2 30W LED Spotlight Headlight Work Light Driving Fog Spot Lamp for Motorcycle ATV Truck, Universal Fit, with 2pcs ON/OFF Button Switch Review

I love the light. It would be nice to have a guide on how to connect them. Not everyone can do it without such instructions.

Shift repeatability was initially poor. I eventually found out that the ground circuit wasn't strong enough (after installing a snap-action switch). When I rode my bike in flasher mode, the police didn't seem to mind, but two civilians tugged at my shoulder, thinking it was me. Law. So now I only use the high beam setting.

This is complete bullshit. You have to flip the switch a few times for them to glow normally. They're not very bright, so if you're buying them in addition to a headlight, look elsewhere. I bought more of these to draw attention to myself when cycling at intersections. not what i was hoping for. I think the old adage is true. You get what you pay for. They were cheap and cheaply made.

I brought them for a motorcycle, they are very bright, perfect for night rides. The low beam is bright enough and the high beam is very bright for nighttime areas. And flashing helps in traffic area for visibility. After owning it for a few months the FRONT COVER AND GLASS fell off on the freeway. Now they are useless, I have to take them off now. It doesn't build, so buzz, the inner rubber seal is held in place by glue that has come loose and the front cover only needed tightening for a couple

Good as long as it works. Installed late October, driven daily so far, February (with 4 week break in December). So, about 2 months before either lamp died; looks like water in the case. Buyers be careful. When I added the wiring, crimp and barrel connectors to connect to the car's factory wiring harness, and a dual switch (because the three-mode bulbs don't sync with a single switch), the bulbs were cheap. Part of a set --- and now I need to add a few more lamps. Maybe spend a little more for…

The high beam is bright enough for fog lights, but the low beam and flash are useless. I'll look for a way to keep the high beams on all the time. I have to re-sync the headlights every time I turn them on, which is inconvenient to say the least as I'm flipping the switch on and off 10-20 times faster than I can (the fuse is under the seat). I had to find longer screws at the hardware store to attach them to the roll bar, flip the lenses over to make them fog lights, and apply CA to the trim…

Don't buy! Very cheap product and workmanship. You get what you pay for. The product looked like an open box when received. There was no wiring diagram for the installation. The bracket was loose so I had to replace the screws. Installed in the shop: First, a switch was defective or a broken wire. When the seller asked about replacing the switch, he replied that delivery would take 10-22 days. Then I connected them directly to power and ground, and finally it worked. Remember, if you decide to…

The attractiveness of these lanterns is quite high. Bright light, focused beam and everything you need to assemble. But the case and bracket are made of lightweight, cheap material that feels fragile. You can also install it in just one position. Given the variety of custom bikes, it would make sense to have an adjustable mount. I was able to install the kit without damaging them and hooked them up pretty well to make them work. Despite the build quality, I was pleased with the finished product