Header banner
Revain logoHome Page
honeywell ademco 5800wave: efficient wireless siren for enhanced security logo

Honeywell Ademco 5800WAVE: Efficient Wireless Siren for Enhanced Security Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.7
🚨 Horns & Sirens, 🕵️‍♂️ Security & Surveillance

View on AmazonView on ЯM

Media

(2)
img 1 attached to Honeywell Ademco 5800WAVE: Efficient Wireless Siren for Enhanced Security
img 2 attached to Honeywell Ademco 5800WAVE: Efficient Wireless Siren for Enhanced Security

Description of Honeywell Ademco 5800WAVE: Efficient Wireless Siren for Enhanced Security

Siren output level is 95 db at three feet LED system status. Transmits module status including mounting tamper low battery and AC loss to the control panel. AC powered with a rechargeable 12 hour battery backup Provides temporal pulse sounding for fire alarms. Compatible with Lynx R Rev 10 or higher and Vista controls that support the 5883 transceiver. Plugs in to any standard duplex receptacle and installs in seconds.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    2
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

Works great as an extra siren

Works well but I've found it's not as loud as an AC siren. Another issue I noticed is that the battery doesn't last very long once charged. Hence the 4 star rating. Maybe just a bad battery. But it's great for adding a remote controlled siren anywhere there's a 110v plug and doesn't need to run wires. It also has a tamper switch that will disable the siren if it is unplugged for any reason. I put it in the garage and it works perfectly. Works perfectly with the Honeywell Lynx Touch and is easy…

Pros
  • Plugs into any standard duplex outlet and installs in seconds
Cons
  • Easy maintenance

Revainrating 3 out of 5

Not as loud as I had hoped, limited range.

Relatively easy to set up once you know how to code. Good control features and functions as well as a tamper switch. A little more than I thought and you should have a separate outlet and one within range of your transmitter. I found the range a bit short as I put other sensors much further away than the outlet from which I was eventually able to get a signal. Noisy when standing right next to it, but it didn't spread as far as I had hoped and coupled with the limited choice of outlets due to…

Pros
  • Reports module status, including tamper, low battery, and power failure to the control panel.
Cons
  • Some defects.

Revainrating 5 out of 5

Noisy. great addition to Honeywell l7000 or 5200

Very Very Loud Siren. If you're used to those tiny x10 sirens, you must know that this generation has the edge. The device covers the entire socket. it is unscrewed for additional protection against unauthorized access. It has a built-in backup battery in case it loses power during an event. To install, all you have to do is open the back of the siren. Attach the battery cable to the circuit board. Set the microswitches to your house code l7000 or 5200. Replace the back cover and connect to the

Pros
  • Siren Output 95dB @ 3ft System Status LED
Cons
  • Updates