🚦 Hooke Road Front LED Turn Signals: High-Quality DRLs for Jeep Wrangler TJ 97-06 Review

You have 3 wires in the picture - it is clear there are only 2 wires and this will not work on 99 TJ as the harness is 3 wires. Do not order for 99 TJ

These bulbs solved all my problems and replaced my factory wiring connector which was shorted and only worked occasionally. Also, they look a lot better. Screws perfectly and connects with ease.

I bought new replacement LED headlights and they flicker badly every time I use my turn signals. I replaced the turn signals with these and as if by magic everything is fine. great headlights! easy to install! Work like a champion!

From the photos you can see that the pattern on the left is the pattern on the signs. Factory wires for installing new ones. I'm not comfortable cutting wires, I bought new ones because they said I could just plug them in

Most people who install them use LEDs for the rest of their lights. It is a serious mistake not to provide a good explanation of how blowdown resistors work and why they were included. Not a word about page markers. I really like the look of them and at some point I'll probably find the time to install them, but it's not trivial.

I installed these on my 2004 Jeep Wrangler TJ. I love the look of these lamps both on and off. I had to put resistors in order for the turn signals to work properly. It wasn't difficult to do. I bought a resistor kit from my local auto parts store. Revain would have been cheaper but didn't want to wait 2 weeks to complete the install. I didn't realize I would need them when purchasing.

Well these lights are good and worth the money. I like that they are a little bit different. Wiring order is black to black, yellow to black with yellow stripe, and red to red-orange. Tip #1: You need an LED relay. They are no longer OEM so you can keep your old one just in case. This relay is located above the steering wheel and is very easy to replace. You need to remove the steering wheel cover, just two large Phillips screws on the bottom, then remove the rubber grommets around the turn…